Yamaha YZF-R125 Service Manual: Chassis
- Adjusting the rear disc brake
- Checking the brake fluid level
- Checking the front brake pads
- Checking the rear brake pads
- Checking the front brake hose
- Checking the rear brake hose
- Bleeding the hydraulic brake system
- Adjusting the drive chain slack
- Lubricating the drive chain
- Checking and adjusting the steering head
- Checking the front fork
- Checking the tires
- Checking the wheels
- Checking and lubricating the cables
Changing the coolant
1. Remove:
Lower side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Radiator cap "1"
WARNINGA hot radiator is under pressure.
Therefore,
do not remove t ...
Adjusting the rear disc brake
1. Check:
Brake pedal position
(distance "a" from the center of the rider footrest
to the center of the brake pedal)
Out of specification Adjust.
2. Adjust:
Brake pedal position
...
Other materials:
Installing the thermostat
1. Install:
Thermostat
NOTE:
Install the thermostat with its breather hole "a"
facing up.
2. Install:
Copper washer
Coolant temperature sensor
CAUTION:Use extreme care when handling the
coolant
temperature sensor. Replace any part that
was dropped or subjected to ...
Bleeding the hydraulic brake system
WARNINGBleed the hydraulic brake system whenever:
the system is disassembled.
a brake hose is loosened, disconnected or
replaced.
the brake fluid level is very low.
brake operation is faulty.
NOTE:
Be careful not to spill any brake fluid or allow
th ...
Checking the shift forks
The following procedure applies to all of the shift
forks.
1. Check:
Shift fork cam follower "1"
Shift fork pawl "2"
Bends/damage/scoring/wear
Replace the
shift fork.
2. Check:
Shift fork guide bar
Roll the shift fork guide bar on a flat surface.
Bends Replace. ...