Yamaha YZF-R125 Service Manual: Checking the wheels

The following procedure applies to both of the wheels.

1. Check:

Wheel Damage/out-of-round → Replace.

WARNING

Never attempt to make any repairs to the wheel.

NOTE:

After a tire or wheel has been changed or replaced, always balance the wheel.

    Checking the tires
    The following procedure applies to both of the tires. 1. Check: Tire pressure Out of specification Regulate. WARNING The tire pressure should only be checked and regulated whe ...

    Checking and lubricating the cables
    The following procedure applies to all of the inner and outer cables. WARNINGDamaged outer cable may cause the cable to corrode and interfere with its movement. Replace damaged outer ca ...

    Other materials:

    Removing the crankshaft
    1. Remove: Crankshaft "1" NOTE: Remove the crankshaft with the crankcase separating tool "2". Make sure the crankcase separating tool is centered over the crankshaft. CAUTION: To protect the end of the crankshaft, place an appropriate sized socket between the c ...

    Checking the horn
    1. Check: Horn resistance Out of specification Replace. a. Disconnect the horn connectors from the horn terminals. b. Connect the pocket tester ( × 1) to the horn terminals. Positive tester probe horn terminal "1" Negative tester probe horn terminal "2" c. Measure t ...

    Installing the front fork legs
    The following procedure applies to both of the front fork legs. 1. Install: Front fork leg Temporarily tighten the upper and lower bracket pinch bolts. NOTE: Make sure the inner tube end position "a" is 24.5 mm (0.96 in) from the top of the upper bracket. 2. Tighten: Lower br ...

    2026 Copyright www.yam-r125.net |