Yamaha YZF-R125 Service Manual: Checking the rear brake pads

The following procedure applies to all of the brake pads.

1. Operate the brake.

2. Check:

  • Rear brake pad Wear indicator groove "a" has almost disappeared
    Replace the brake pads as a set.

    Refer to "REAR BRAKE" on page 4-28.

Checking the rear brake pads


    Checking the front brake pads
    The following procedure applies to all of the brake pads. 1. Operate the brake. 2. Check: Front brake pad Wear indicator grooves "a" have almost disappeared Replace the brake pads as a ...

    Checking the front brake hose
    1. Check: Brake hose "1" Cracks/damage/wear  Replace. 2. Check: Brake hose holder "2" Loose connection Tighten the holder bolt. 3. Hold the vehicle upright and apply ...

    Other materials:

    Adjusting the drive chain slack
    NOTE: The drive chain slack must be checked at the tightest point on the chain. CAUTION:A drive chain that is too tight will overload the engine and other vital parts, and one that is too loose can skip and damage the swingarm or cause an accident. Therefore, keep the drive ...

    Checking the piston rings
    1. Measure: Piston ring side clearance Out of specification Replace the piston and piston rings as a set. NOTE: Before measuring the piston ring side clearance, eliminate any carbon deposits from the piston ring grooves and piston rings. 2. Install: Piston ring (into the cylind ...

    Intake air pressure sensor
    1. Check: Intake air pressure sensor output voltage Out of specification Replace the throttle body. a. Connect the pocket tester (DC 20 V) to the throttle body sensor assembly coupler as shown. Positive tester probe pink/white "1" Negative tester probe gray/black "2" ...

    2026 Copyright www.yam-r125.net |