Yamaha YZF-R125 Service Manual: Front brake
- Introduction
- Checking the front brake disc
- Replacing the front brake pads
- Removing the front brake caliper
- Checking the front brake caliper
- Assembling the front brake caliper
- Installing the front brake caliper
- Removing the front brake master cylinder
- Checking the front brake master cylinder
- Installing the front brake master cylinder
Installing the rear wheel (disc)
1. Install:
Rear brake disc
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4- ...
Introduction
WARNINGDisc brake components rarely require
disassembly.
Therefore, always follow these preventive
measures:
Never disassemble brake components unless
absolutely necessa ...
Other materials:
Checking the camshaft sprocket and timing chain guide
1. Check:
Camshaft sprocket
More than 1/4 tooth wear "a" Replace
the
camshaft sprocket, timing chain and crankshaft
as a set.
a. 1/4 tooth
b. Correct
1. Timing chain roller
2. Camshaft sprocket
2. Check:
Timing chain guide (exhaust side)
Damage/wear Replace.
...
Troubleshooting
The starter motor fails to turn.
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Left lower side cowling
4. Left upper side cowling
...
Checking the valve springs
The following procedure applies to all of the
valve springs.
1. Measure:
Valve spring free length "a"
Out of specification Replace the valve
spring.
2. Measure:
Compressed valve spring force "a"
Out of specification Replace the valve
spring.
b. Installed length
3. ...