Yamaha YZF-R125 Service Manual: Cooling system

Installing the shift forks and shift drum assembly
1. Install: Shift fork-L "1" Shift fork-C "2" Shift fork-R "3" Shift drum assembly "4" Springs Shift fork guide bar "5" NOTE: The embossed marks on the shift forks should face towar ...

Radiator
...

Other materials:

Changing the engine oil
1. Remove: Right bottom cowling Right upper side cowling Right lower side cowling Refer to "GENERAL CHASSIS" on page 4-1. 2. Start the engine, warm it up for several minutes, and then turn it off. 3. Place a container under the engine oil drain bolt. 4. Install: Engine oil d ...

Assembling the main axle and drive axle
1. Install: Toothed washer "1" Circlip "2" NOTE: Be sure to install the circlip so that its sharp edge "a" is facing away from the toothed washer and gear. Be sure the circlip ends "b" are positioned at the axle spline groove "c". 2. Install: 2nd pinion gear "1" NO ...

Checking the fid (fast idle solenoid)
1. Disconnect: FID (fast idle solenoid) coupler 2. Check: FID (fast idle solenoid) resistance a. Disconnect the FID (fast idle solenoid) coupler from the FID. b. Connect the pocket tester ( × 10) to the terminals of the FID (fast idle solenoid). Positive tester probe ...

2025 Copyright www.yam-r125.net |