Yamaha YZF-R125 Service Manual: Installing the radiator
1. Fill:
- Cooling system (with the specified amount of the recommended coolant) Refer to "CHANGING THE COOLANT" on page 3-15.
2. Check:
- Cooling system
Leaks
Repair or replace any
faulty part.
3. Measure:
- Radiator cap opening pressure
Below the specified pressure
Replace
the radiator cap.Refer to "CHECKING THE RADIATOR" on page 6-3.
Checking the radiator
1. Check:
Radiator fins
obstruction clean.
Apply compressed air to the rear of the radiator.
Damage repair or replace.
NOTE:
Straighten any flattened fins with a thin, flat-head
scre ...
Thermostat
...
Other materials:
Installing the fuel hose
1. Install:
Fuel hose
Fuel hose connector cover
CAUTION:When installing the fuel hose, make sure
that
it is securely connected, and that the fuel
hose connector cover is in the correct position,
otherwise the fuel hose will not be properly
installed.
NOTE:
W ...
Bleeding the hydraulic brake system
WARNINGBleed the hydraulic brake system whenever:
the system is disassembled.
a brake hose is loosened, disconnected or
replaced.
the brake fluid level is very low.
brake operation is faulty.
NOTE:
Be careful not to spill any brake fluid or allow
th ...
Introduction
WARNINGDisc brake components rarely require
disassembly.
Therefore, always follow these preventive
measures:
Never disassemble brake components unless
absolutely necessary.
If any connection on the hydraulic brake
system is disconnected, the entire brake
sy ...