Setting the diagnostic mode
1. Set the main switch to "OFF" and the engine stop switch to "
".
2. Disconnect the self-diagnosis signal connector "1", and then connect the FI
diagnostic tool "2" as
shown.
3. Disconnect the fuel pump coupler.
4. While pressing the "MODE" button, set the main switch to "ON".
NOTE:
...
Checking the coolant temperature sensor
1. Remove:
Coolant temperature sensor
WARNING
Handle the coolant temperature sensor
with special care.
Never subject the coolant temperature sensor
to strong shocks. If the coolant temperature
sensor is dropped, replace it.
2. Check:
Coolant temper ...
Adjusting the valve clearance
The following procedure applies to all of the
valves.
NOTE:
Valve clearance adjustment should be made
on a cold engine, at room temperature.
When the valve clearance is to be measured or
adjusted, the piston must be at top dead center
(TDC) on the compression stroke.
1. Remove:
...