Yamaha YZF-R125 Service Manual: Diagnostic mode
It is possible to monitor the sensor output data or check the activation of
actuators with the FI diagnostic
tool connected to the vehicle and set to the normal mode or the diagnostic
monitoring mode.
Troubleshooting method
The engine operation is not normal and the
engine trouble warning light comes on.
1. Check:
Fault code number
a. Check the fault code number displayed on
the FI diagnostic tool.
b. Identi ...
Setting the normal mode
NOTE:
The engine speed, coolant temperature, and fault code, if detected, can be
displayed on the LCD of the
FI diagnostic tool when the tool is connected to the vehicle and is set to the
normal ...
Other materials:
Checking and lubricating the cables
The following procedure applies to all of the inner
and outer cables.
WARNINGDamaged outer cable may cause the cable to
corrode and interfere with its movement. Replace
damaged outer cable and inner cables
as soon as possible.
1. Check:
Outer cable
Damage Replace.
2 ...
Checking the stator coil
1. Disconnect:
Stator coil coupler
(from the wire harness)
2. Check:
Stator coil resistance
Out of specification → Replace the
crankshaft
position sensor/stator assembly.
a. Connect the pocket tester ( ×
1) to the stator
coil coupler as shown.
b. Measure the sta ...
Safe Riding
Perform the pre-operation checks each
time you use the vehicle to make sure it
is in safe operating condition. Failure to
inspect or maintain the vehicle properly
increases the possibility of an accident
or equipment damage. See page 4-1
for a list of pre-operation checks.
This motor ...