Chassis tightening torques
NOTE:
First, tighten the lower ring nut to approximately 48 Nm (4.8 m.kg,
35 ft.lb) with a torque wrench, then
loosen the lower ring nut completely.
Retighten the lower ring nut to 13 Nm (1.3 m.kg, 9.4 ft.lb) with a
torque wrench.
...
Starting the engine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sidestand
up.
1. Turn the key to "ON" and make
sure ...
Checking the radiator fan motor
1. Check:
Radiator fan motor
Faulty/rough movement → Replace.
a. Disconnect the radiator fan motor coupler
from the wire harness.
b. Connect the battery (DC 12 V) as shown.
Positive tester probe →
blue "1"
Negative tester probe →
black "2"
c. Measure ...