Yamaha YZF-R125 Service Manual: Installing the oil pump

Yamaha YZF-R125 Service Manual / Engine / Oil pump / Installing the oil pump

1. Install:

  • Oil pump assembly

CAUTION:

After tightening the screws, make sure the oil pump turns smoothly.

    Assembling the oil pump
    1. Lubricate: Oil pump inner rotor Oil pump outer rotor Oil pump driven gear (with the recommended lubricant) 2. Install: Oil pump outer rotor Oil pump inner rotor "1" Oil pump dr ...

    Shift shaft
    ...

    Other materials:

    Replacing the rear brake pads
    NOTE: When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper. 1. Remove: Brake pads Brake pad spring NOTE: To remove the inner brake pad "1", push down on the brake caliper bracket so that there is space to remove the brake pa ...

    Adjusting the throttle cable free play
    Throttle cable free play The throttle cable free play should measure 3.0-5.0 mm (0.12-0.20 in) at the throttle grip. Periodically check the throttle cable free play and, if necessary, adjust it as follows. TIP The engine idling speed must be correctly adjusted before checkin ...

    Important manual information
    Particularly important information is distinguished in this manual by the following notations: This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING ...

    2026 Copyright www.yam-r125.net |