Tachometer
The electric tachometer allows the rider to monitor the engine speed and keep it within the ideal power range.
When the key is turned to "ON", the tachometer needle will sweep once across the r/min range and then return to zero r/min in order to test the electrical circuit.
NOTICE
Do not operate the engine in the tachometer
red zone.
Red zone: 10000 r/min and above
Indicator and warning lights
Multi-function displayAssembling the main axle and drive axle
1. Install:
Toothed washer "1"
Circlip "2"
NOTE:
Be sure to install the circlip so that its sharp
edge "a" is facing away from the toothed washer
and gear.
Be sure the circlip ends "b" are positioned at
the axle spline groove "c".
2. Install:
2nd pinion gear "1"
NO ...
Engine oil and oil filter element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter element
replaced at the intervals specified
in the periodic maintenance and lubrication
chart.
To check the engine oil level
Place the vehicle on a level surface
and hol ...
Checking the speed sensor
1. Check:
Speed sensor output voltage
Out of specification → Replace.
a. Connect the pocket tester (DC 20 V) to the
speed sensor coupler (wire harness end) as
shown.
Positive tester probe
gray "1"
Negative tester probe
gray/black "2"
b. Set the main switch to "ON".
c. ...