Yamaha YZF-R125 Service Manual: Checking the bearings and oil seal

Yamaha YZF-R125 Service Manual / Engine / Crankcase / Checking the bearings and oil seal

1. Check:

  • Bearings

Clean and lubricate the bearings, and then rotate the inner race with your finger.

Rough movement Replace.


  • Oil seal

Damage/wear Replace.


    Checking the timing chain and timing chain guide
    1. Check: Timing chain Damage/stiffness Replace the timing chain and camshaft sprocket as a set. 2. Check: Timing chain guide (intake side) Damage/wear Replace. Checking the oil stra ...

    Installing the bearing retainer
    1. Install: Bearing retainer "1" NOTE: Install the bearing retainer "1" with its "OUT" mark "a" facing outward. Apply locking agent (LOCTITE) to the threads of the bearing retainer bo ...

    Other materials:

    Cleaning the air filter element
    NOTE: There is a check hose "1" at the bottom of the air filter case. If dust and/or water collects in this hose, clean the air filter element and air filter case. 1. Remove: Rider seat Refer to "GENERAL CHASSIS" on page 4-1. 2. Remove: Fuel tank Refer to "FUEL TANK" on page ...

    Checking the spark plug
    The spark plug is an important engine component, which is easy to check. Since heat and deposits will cause any spark plug to slowly erode, the spark plug should be removed and checked in accordance with the periodic maintenance and lubrication chart. In addition, the condition of the ...

    Adjusting the throttle cable free play
    Throttle cable free play The throttle cable free play should measure 3.0-5.0 mm (0.12-0.20 in) at the throttle grip. Periodically check the throttle cable free play and, if necessary, adjust it as follows. TIP The engine idling speed must be correctly adjusted before checkin ...

    2026 Copyright www.yam-r125.net |