Yamaha YZF-R125 Service Manual: Types of bulbs
The bulbs used on this vehicle are shown in the illustration.
- Bulbs "a" and "b" are used for the headlights and usually use a bulb holder that must be detached before removing the bulb. The majority of these types of bulbs can be removed from their respective socket by turning them counterclockwise
- Bulbs "c" are used for turn signal and tail/brake lights and can be removed from the socket by pushing and turning the bulb counterclockwise.
- Bulbs "d" and "e" are used for meter and indicator lights and can be removed from their respective socket by carefully pulling them out.
Checking the bulbs and bulb sockets
NOTE:
Do not check any of the lights that use LEDs.
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continuity
between the terminals.
Damage/wear Repa ...
Checking the condition of the bulbs
The following procedure applies to all of the
bulbs.
1. Remove:
Bulb
WARNINGSince the headlight bulbs get extremely
hot,
keep flammable products and your hands
away from them ...
Other materials:
Installing the clutch
1. Install:
Conical spring washer "1"
NOTE:
Install the conical spring washer as shown in the
illustration.
2. Install:
Clutch housing
Thrust washer "1"
NOTE:
Be sure to install the thrust washer so that its
sharp edge "a" is facing away from the clutch
boss.
3. Instal ...
Checking the front brake hose
1. Check:
Brake hose "1"
Cracks/damage/wear
Replace.
2. Check:
Brake hose holder "2"
Loose connection Tighten the
holder bolt.
3. Hold the vehicle upright and apply the front
brake several times.
4. Check:
Brake hose
Brake fluid leakage Replace the
da ...
Removing the throttle body
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Disconnect:
Fuel hose
WARNINGCover the fuel hose connections with a
cloth
when disconnecting them. Residual pressure
in the fuel lines could cause fuel to
spurt out when removing the h ...