Important manual information
Be a Responsible OwnerVInstalling the handlebars
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Install:
Front brake master cylinder "1"
Front brake master cylinder holder "2"
Front brake light switch
NOTE:
Install the brake master cyl ...
Assembling the main axle and drive axle
1. Install:
Toothed washer "1"
Circlip "2"
NOTE:
Be sure to install the circlip so that its sharp
edge "a" is facing away from the toothed washer
and gear.
Be sure the circlip ends "b" are positioned at
the axle spline groove "c".
2. Install:
2nd pinion gear "1"
NO ...
Installing the water pump
1. Install:
Water pump assembly "1"
O-rings "2"
NOTE:
Align the projection "a" on the impeller shaft
with the slit "b" on the camshaft sprocket bolt.
Lubricate the O-rings with a thin coat of lithiumsoap-
based grease.
2. Fill:
Cooling system
(with the specified amou ...