Yamaha YZF-R125 Owners Manual: Replacing a turn signal light bulb

  1. Remove the turn signal light lens by removing the screw.


  1. Screw

  1. Remove the burnt-out bulb by pushing it in and turning it counterclockwise.
  2. Insert a new bulb into the socket, push it in, and then turn it clockwise until it stops.
  3. Install the lens by installing the screw. NOTICE: Do not overtighten the screw, otherwise the lens may break.

    Tail/brake light
    This model is equipped with an LEDtype tail/brake light. If the tail/brake light does not come on, have a Yamaha dealer check it. ...

    Replacing the license plate light bulb
    Remove the socket (together with the bulb) by pulling it out. License plate light bulb Remove the burnt-out bulb by pulling it out. Insert a new bulb into the socket. ...

    Other materials:

    Disassembling the water pump
    1. Remove: Water pump seal "1" NOTE: Remove the water pump seal from the inside of the water pump housing "2". 2. Remove: Bearing "1" NOTE: Remove the bearing from the outside of the water pump housing "2". ...

    Checking the horn
    1. Check: Horn resistance Out of specification Replace. a. Disconnect the horn connectors from the horn terminals. b. Connect the pocket tester ( × 1) to the horn terminals. Positive tester probe horn terminal "1" Negative tester probe horn terminal "2" c. Measure t ...

    Checking the condition of the bulb sockets
    The following procedure applies to all of the bulb sockets. 1. Check: Bulb socket (for continuity) (with the pocket tester) No continuity Replace. NOTE: Check each bulb socket for continuity in the same manner as described in the bulb section, however, note the following. a. Install a ...

    2026 Copyright www.yam-r125.net |