Yamaha YZF-R125 Service Manual: Checking the connecting arms and relay arm

Yamaha YZF-R125 Service Manual / Chassis / Rear shock absorber assembly / Checking the connecting arms and relay arm

1. Check:

  • Connecting arms
  • Relay arm Damage/wear Replace.

2. Check:

  • Bearings
  • Oil seals Damage/pitting Replace.

3. Check:

Spacers Damage/scratches Replace.


    Checking the rear shock absorber assembly
    1. Check: Rear shock absorber rod Bends/damage Replace the rear shock absorber assembly. Rear shock absorber Oil leaks Replace the rear shock absorber assembly. Spring Damage ...

    Installing the relay arm
    1. Lubricate: Spacers Bearings Oil seals Bolts (unthreaded shaft portion only) 2. Install: Bearing "1" (to the relay arm) Oil seal "2" (to the relay arm) 3. Rear shoc ...

    Other materials:

    Checking the cylinder head breather hose
    1. Remove: Left side panel Refer to "GENERAL CHASSIS" on page 4-1. 2. Check: Cylinder head breather hose "1" Cracks/damage → Replace. Loose connection → Connect properly. CAUTION:Make sure the cylinder head breather hose is routed correctly. ...

    Checking the condition of the bulb sockets
    The following procedure applies to all of the bulb sockets. 1. Check: Bulb socket (for continuity) (with the pocket tester) No continuity Replace. NOTE: Check each bulb socket for continuity in the same manner as described in the bulb section, however, note the following. a. Install a ...

    Rear wheel
    To remove the rear wheel WARNING To avoid injury, securely support the vehicle so there is no danger of it falling over. Loosen the axle nut. Axle nut Drive chain slack adjusting bolt Locknut Brake caliper Lift the rear wheel off the ground according to the pr ...

    2026 Copyright www.yam-r125.net |