
Owner's tool kit
General maintenance and lubrication chartInstalling the relay arm
1. Lubricate:
Spacers
Bearings
Oil seals
Bolts (unthreaded shaft portion only)
2. Install:
Bearing "1"
(to the relay arm)
Oil seal "2"
(to the relay arm)
3. Rear shock absorber assembly
4. Relay arm
5. Connecting arm
A. Left side
B. Right side ...
Checking the ignition spark gap
1. Check:
Ignition spark gap
Out of specification Perform the
ignition
system troubleshooting, starting with step 5.
Refer to "TROUBLESHOOTING" on page
8-3.
NOTE:
If the ignition spark gap is within specification,
the ignition system circuit is operating normally.
a. Disconnect the spa ...
Checking the crankshaft position sensor
1. Disconnect:
Crankshaft position sensor coupler
(from the wire harness)
2. Check:
Crankshaft position sensor resistance
Out of specification Replace
the crankshaft
position sensor/stator assembly.
a. Connect the pocket tester ( × 100) to the
crankshaft position sensor c ...