Yamaha YZF-R125 Owners Manual: Lubricating the swingarm pivots
The swingarm pivots must be lubricated at the intervals specified in the periodic maintenance and lubrication chart.
| Recommended lubricant: Molybdenum disulfide grease |
Checking and lubricating the sidestand
Checking and lubricating the sidestand
The operation of the sidestand should
be checked before each ride, and the
sidestand pivot and metal-to-metal
contact surfaces should be lubricated if ...
Checking the front fork
The condition and operation of the front
fork must be checked as follows at the
intervals specified in the periodic maintenance
and lubrication chart.
To check the condition
Check the inner tu ...
Other materials:
Removing the handlebars
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Remove:
Handlebar grip "1"
NOTE:
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handleb ...
Installing the cylinder head
1. Install:
Cylinder head
NOTE:
Pass the timing chain through the timing chain
cavity.
2. Tighten:
Cylinder head bolts "1"
Cylinder head bolts "2"
NOTE:
Lubricate the cylinder head bolts and washers
with engine oil.
Tighten the cylinder head bolts in the proper
tighten ...
Changing the coolant
1. Remove:
Lower side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Radiator cap "1"
WARNINGA hot radiator is under pressure.
Therefore,
do not remove the radiator cap when the engine
is hot. Scalding hot fluid and steam may
be blown out, which c ...