Yamaha YZF-R125 Service Manual: Adjusting the rear wheel static balance
NOTE:
- After replacing the tire, wheel or both, the rear wheel static balance should be adjusted.
- Adjust the rear wheel static balance with the brake disc and rear wheel drive hub installed.
1. Adjust:
- Rear wheel static balance Refer to "ADJUSTING THE FRONT WHEEL STATIC BALANCE" on page 4-9.
Checking and replacing the rear wheel sprocket
1. Check:
Rear wheel sprocket
More than 1/4 tooth "a" wear
Replace the
rear wheel sprocket.
Bent teeth Replace the rear
wheel sprocket.
b. Correct
1. Drive chain roller
2. ...
Installing the rear wheel (disc)
1. Install:
Rear brake disc
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4- ...
Other materials:
Checking the clutch housing
1. Check:
Clutch housing dogs "1"
Damage/pitting/wear
Deburr the clutch
housing dogs or replace the clutch housing.
NOTE:
Pitting on the clutch housing dogs will cause erratic
clutch operation.
2. Check:
Bearing
Damage/wear Replace the
bearing and
clutch housin ...
Checking the fid (fast idle solenoid)
1. Disconnect:
FID (fast idle solenoid) coupler
2. Check:
FID (fast idle solenoid) resistance
a. Disconnect the FID (fast idle solenoid) coupler
from the FID.
b. Connect the pocket tester ( × 10)
to the terminals
of the FID (fast idle solenoid).
Positive tester probe ...
Fuel
Make sure there is sufficient gasoline in
the tank.
WARNING
Gasoline and gasoline vapors are
extremely flammable. To avoid fires
and explosions and to reduce the
risk of injury when refueling, follow
these instructions.
Before refueling, turn off the engine
and be sure that no on ...