Yamaha YZF-R125 Owners Manual: Replacing the license plate light bulb
- Remove the socket (together with the bulb) by pulling it out.
-
License plate light bulb
- Remove the burnt-out bulb by pulling it out.
- Insert a new bulb into the socket.
- Install the socket (together with the bulb) by pushing it in.
Replacing a turn signal light bulb
Remove the turn signal light lens
by removing the screw.
Screw
Remove the burnt-out bulb by
pushing it in and turning it counterclockwise.
Insert a new bulb into the so ...
Replacing an auxiliary light bulb
This model is equipped with two auxiliary
lights. If an auxiliary light bulb burns
out, replace it as follows.
Remove the socket (together with
the bulb) by pulling it out.
Aux ...
Other materials:
Removing the starter clutch
1. Remove:
Starter clutch bolts "1"
NOTE:
While holding the generator rotor "2" with the
sheave holder "3", remove the starter clutch
bolts.
Do not allow the sheave holder to touch the
projection on the generator rotor.
...
Removing the lower bracket
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Remove:
Upper ring nut
Rubber washer
Lower ring nut "1"
Lower bracket
NOTE:
Remove the lower ring nut with the steering nut
wrench "2".
...
Checking the rear brake disc
1. Remove:
Rear wheel
Refer to "REAR WHEEL" on page 4-12.
2. Check:
Brake disc
Damage/galling → Replace.
3. Measure:
Brake disc deflection
Out of specification → Correct the brake
disc
deflection or replace the brake disc.
Refer to "CHECKING THE FRONT BRAKE
DIS ...