Yamaha YZF-R125 Owners Manual: Clutch lever


Clutch lever

  1. Clutch lever

The clutch lever is located at the left handlebar grip. To disengage the clutch, pull the lever toward the handlebar grip. To engage the clutch, release the lever. The lever should be pulled rapidly and released slowly for smooth clutch operation.

The clutch lever is equipped with a clutch switch, which is part of the ignition circuit cut-off system.

    Handlebar switches
    Left Left 1. Pass switch "PASS" 2. Dimmer switch "/" 3. Turn signal switch "/" 4. Horn switch"" Right Right Engine stop switch "/" Start switch"" Pass switch "PASS" Press t ...

    Shift pedal
    Shift pedal Shift pedal The shift pedal is located on the left side of the engine and is used in combination with the clutch lever when shifting the gears of the 6-speed constant- m ...

    Other materials:

    Checking the diode
    1. Check: Diode Out of specification Replace. NOTE: The pocket tester or the analog pocket tester readings are shown in the following table. a. Disconnect the diode from the wire harness. b. Connect the pocket tester ( × 1) to the diode terminals as shown. c. Check the diod ...

    Checking the fuel line
    1. Remove: Left side panel Refer to "GENERAL CHASSIS" on page 4-1. 2. Lift the fuel tank. (Do not disconnect the fuel hose, drain hose 3. Check: Fuel hose "1" Cracks/damage → Replace. Loose connection Connect properly. 4. Install: Fuel tank Refer to "FUEL TANK" on pa ...

    Replacing the front brake pads
    NOTE: When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper. 1. Measure: Brake pad wear limit "a" Out of specification Replace the brake pads as a set. 2. Install: Brake pad support Brake pad spring Brake pads ...

    2026 Copyright www.yam-r125.net |