Yamaha YZF-R125 Owners Manual: Shift pedal
Shift pedal
- Shift pedal
The shift pedal is located on the left side of the engine and is used in combination with the clutch lever when shifting the gears of the 6-speed constant- mesh transmission equipped on this motorcycle.
Clutch lever
Clutch lever
Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handlebar
grip. To engage the clutch, release
th ...
Brake lever
Brake lever
Brake lever
The brake lever is located at the right
handlebar grip. To apply the front
brake, pull the lever toward the handlebar
grip. ...
Other materials:
Removing the piston
1. Remove:
Piston pin clips "1"
Piston pin "2"
Piston "3"
CAUTION:Do not use a hammer to drive the piston
pin
out.
NOTE:
Before removing the piston pin clip, cover the
crankcase opening with a clean rag to prevent
the piston pin clip from falling in ...
Measuring the compression pressure
NOTE:
Insufficient compression pressure will result in a
loss of performance.
1. Measure:
Valve clearance
Out of specification →Adjust.
Refer to "ADJUSTING THE VALVE CLEARANCE"
on page 3-3.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Remove:
...
Intake air pressure sensor
1. Check:
Intake air pressure sensor output voltage
Out of specification Replace the throttle
body.
a. Connect the pocket tester (DC 20 V) to the
throttle body sensor assembly coupler as
shown.
Positive tester probe
pink/white "1"
Negative tester probe
gray/black "2"
...