Yamaha YZF-R125 Owners Manual: Rider seat

To remove the rider seat

  1. Insert the key into the seat lock, and then turn it clockwise.


  1. Seat lock

  2. Open.

  1. Pull the rider seat off.

To install the rider seat

1. Insert the projection on the front of the rider seat into the seat holder as shown.


  1. Projection

  2. Seat holder

  1. Push the rear of the rider seat down to lock it in place.
  2. Turn the key counterclockwise, and then remove it.

TIP
Make sure that the rider seat is properly secured before riding.

    Catalytic converters
    This vehicle is equipped with catalytic converters in the exhaust system. WARNING The exhaust system is hot after operation. To prevent a fire hazard or burns: Do not park the vehicle nea ...

    Sidestand
    The sidestand is located on the left side of the frame. Raise the sidestand or lower it with your foot while holding the vehicle upright. TIP The built-in sidestand switch is part of the ign ...

    Other materials:

    Throttle position sensor
    1. Check: Throttle position sensor a. Connect the digital circuit tester to the terminals of the throttle body sensor assembly coupler as shown. Positive tester probe → gray/red terminal "1" Negative tester probe → gray/black terminal "2" b. Measure the throttle pos ...

    Engine tightening torques
    Cylinder head tightening sequence: Generator cover tightening sequence: Clutch cover tightening sequence: Crankcase tightening sequence: A. Left crankcase B. Right crankcase ...

    Checking the drive sprocket
    1. Check: Drive sprocket More than 1/4 tooth "a" wear Replace the drive chain sprockets as a set. Bent teeth Replace the drive chain sprockets as a set. b. Correct 1. Drive chain roller 2. Drive chain sprocket Checking the rear wheel sprocket Refer to "CHECKING AND R ...

    2026 Copyright www.yam-r125.net |