Yamaha YZF-R125 Service Manual: Checking the balancer gears and primary drive gear

Yamaha YZF-R125 Service Manual / Engine / Balancer gear / Checking the balancer gears and primary drive gear

1. Check:

  • Balancer drive gear
  • Balancer driven gear Cracks/damage/wear Replace.

2. Check:

  • Primary drive gear Refer to "CHECKING THE PRIMARY DRIVE GEAR" on page 5-43.
    Removing the primary drive gear and balancer gears
    1. Loosen: Primary drive gear nut "1" NOTE: Place the aluminum plate "a" between the balancer drive gear "2" and the balancer driven gear "3", and then loosen the primary drive gear nut. ...

    Installing the primary drive gear and balancer gears
    1. Install: Balancer driven gear "1" Lock washer Balancer drive gear "2" Primary drive gear Washer "3" Balancer driven gear nut Primary drive gear nut NOTE: Align the punch mar ...

    Other materials:

    Checking the oil pump
    1. Check: Oil pump drive gear Oil pump driven gear Oil pump housing Oil pump housing cover Cracks/damage/wear Replace the defective part(s). 2. Measure: Inner-rotor-to-outer-rotor-tip clearance "a" Outer-rotor-to-oil-pump-housing clearance "b" - Oil-pump-housing-to-inn ...

    Replacing a turn signal light bulb
    Remove the turn signal light lens by removing the screw. Screw Remove the burnt-out bulb by pushing it in and turning it counterclockwise. Insert a new bulb into the socket, push it in, and then turn it clockwise until it stops. Install the lens by installing ...

    Circuit diagram
    4. Main fuse 5. Main switch 9. Battery 25.ECU (engine control unit) 36.License plate light 37.Tail/brake light 44.Headlight relay 46.Pass switch 47.Dimmer switch 51.Headlight (low beam) 52.Auxiliary light 54.Headlight (high beam) 58.Meter light 60.High beam indicator light 64.Ignit ...

    2026 Copyright www.yam-r125.net |