Yamaha YZF-R125 Owners Manual: Brake lever


Brake lever

  1. Brake lever

The brake lever is located at the right handlebar grip. To apply the front brake, pull the lever toward the handlebar grip.

    Shift pedal
    Shift pedal Shift pedal The shift pedal is located on the left side of the engine and is used in combination with the clutch lever when shifting the gears of the 6-speed constant- m ...

    Brake pedal
    Brake pedal Brake pedal The brake pedal is on the right side of the motorcycle. To apply the rear brake, press down on the brake pedal. ...

    Other materials:

    Adjusting the exhaust gas volume
    NOTE: Be sure to set the CO density level to standard, and then adjust the exhaust gas volume. 1. Remove: Rider seat Refer to "GENERAL CHASSIS" on page 4-1. 2. Set the main switch to "OFF". 3. Disconnect: Self-diagnosis signal connector "1" 4. Connect: FI diagnostic tool "2 ...

    Replacing the rear brake pads
    NOTE: When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper. 1. Remove: Brake pads Brake pad spring NOTE: To remove the inner brake pad "1", push down on the brake caliper bracket so that there is space to remove the brake pa ...

    Checking the rectifier/regulator
    1. Check: Rectifier/regulator output voltage Out of specification → Replace the rectifier/ regulator. a. Set the engine tachometer to the spark plug lead. b. Connect the pocket tester (DC 20 V) to the rectifier/regulator coupler as shown. Positive tester probe red "1" Negat ...

    2026 Copyright www.yam-r125.net |