When parking, stop the engine, and then remove the key from the main switch.
WARNING
Checking and lubricating the cables
The following procedure applies to all of the inner
and outer cables.
WARNINGDamaged outer cable may cause the cable to
corrode and interfere with its movement. Replace
damaged outer cable and inner cables
as soon as possible.
1. Check:
Outer cable
Damage Replace.
2 ...
Adjusting the engine idling speed
The engine idling speed must be
checked and, if necessary, adjusted as
follows at the intervals specified in the
periodic maintenance and lubrication
chart.
The engine should be warm before
making this adjustment.
Remove panel A.
Check the engine idling speed
and, if necessary, ...
Setting the diagnostic mode
1. Set the main switch to "OFF" and the engine stop switch to "
".
2. Disconnect the self-diagnosis signal connector "1", and then connect the FI
diagnostic tool "2" as
shown.
3. Disconnect the fuel pump coupler.
4. While pressing the "MODE" button, set the main switch to "ON".
NOTE:
...