Yamaha YZF-R125 Owners Manual: Cast wheels
To maximize the performance, durability, and safe operation of your vehicle, note the following points regarding the specified wheels.
- The wheel rims should be checked for cracks, bends or warpage before each ride. If any damage is found, have a Yamaha dealer replace the wheel. Do not attempt even the smallest repair to the wheel. A deformed or cracked wheel must be replaced.
- The wheel should be balanced whenever either the tire or wheel has been changed or replaced. An unbalanced wheel can result in poor performance, adverse handling characteristics, and a shortened tire life.
- Ride at moderate speeds after changing a tire since the tire surface must first be "broken in" for it to develop its optimal characteristics.
Tires
To maximize the performance, durability,
and safe operation of your motorcycle,
note the following points regarding
the specified tires.
Tire air pressure
The tire air pressure should be check ...
Adjusting the clutch lever free play
Adjusting the clutch lever free play
Clutch lever free play adjusting bolt
Clutch lever free play
The clutch lever free play should measure
10.0-15.0 mm (0.39-0.59 in) as
shown. Perio ...
Other materials:
Removing the front wheel (disc)
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Elevate:
Front wheel
NOTE:
Place the vehicle on a suitable stand so that the
front wheel is elevated.
3. Remove:
Front brake caliper
NO ...
Checking the starter motor
1. Check:
Commutator
Dirt Clean with 600 grit
sandpaper.
2. Measure:
Commutator diameter "a"
Out of specification Replace
the starter
motor.
3. Measure:
Mica undercut "a"
Out of specification Scrape
the mica to the
proper measurement with a hacksaw blade
...
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand upright.
Check that the motorcycle is in a
stable and level position before starting
any maintenance. A ...