NOTICE
Some models are equipped with
matte colored finished parts. Be
sure to consult a Yamaha dealer for
advice on what products to use before
cleaning the vehicle. Using a
brush, harsh chemical products or
cleaning compounds when cleaning
these parts will scratch or damage
their surface. Wax also should not
be applied to any matte colored finished
parts.
Installing the water pump
1. Install:
Water pump assembly "1"
O-rings "2"
NOTE:
Align the projection "a" on the impeller shaft
with the slit "b" on the camshaft sprocket bolt.
Lubricate the O-rings with a thin coat of lithiumsoap-
based grease.
2. Fill:
Cooling system
(with the specified amou ...
Checking the turn signal relay
1. Check:
Turn signal relay input voltage
Out of specification →The wiring circuit
from
the main switch to the turn signal relay coupler
is faulty and must be repaired.
a. Connect the pocket tester (DC 20 V) to the
turn signal relay terminal as shown.
- Positive tester probe
b ...
Troubleshooting
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur during
operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts
repre ...