Left view
Description
Right viewChecking the ignition spark gap
1. Check:
Ignition spark gap
Out of specification Perform the
ignition
system troubleshooting, starting with step 5.
Refer to "TROUBLESHOOTING" on page
8-3.
NOTE:
If the ignition spark gap is within specification,
the ignition system circuit is operating normally.
a. Disconnect the spa ...
Checking the tires
The following procedure applies to both of the
tires.
1. Check:
Tire pressure
Out of specification Regulate.
WARNING
The tire pressure should only be checked
and regulated when the tire temperature
equals the ambient air temperature.
The tire pressure must be adjuste ...
Installing the rear brake master cylinder
1. Install:
Copper washers "1"
Brake hose "2"
Rear brake light switch "3"
WARNINGProper brake hose routing is essential to
insure
safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-33.
CAUTION:When installing the brake hose onto the
brake master ...