Yamaha YZF-R125 Service Manual: Water pump

Installing the thermostat

1. Install: Thermostat NOTE: Install the thermostat with its breather hole "a" facing up. 2. Install: Copper washer Coolant temperature sensor CAUTION:Use extreme care when ...

Disassembling the water pump

1. Remove: Water pump seal "1" NOTE: Remove the water pump seal from the inside of the water pump housing "2". 2. Remove: Bearing "1" NOTE: Remove the bearing from the outside of ...

Other materials:

Checking the coolant temperature sensor
1. Remove: Coolant temperature sensor WARNING Handle the coolant temperature sensor with special care. Never subject the coolant temperature sensor to strong shocks. If the coolant temperature sensor is dropped, replace it. 2. Check: Coolant temper ...

Checking the speed sensor
1. Check: Speed sensor output voltage Out of specification → Replace. a. Connect the pocket tester (DC 20 V) to the speed sensor coupler (wire harness end) as shown. Positive tester probe gray "1" Negative tester probe gray/black "2" b. Set the main switch to "ON". c. ...

Checking the fuses
The following procedure applies to all of the fuses. CAUTION:To avoid a short circuit, always turn the main switch to "OFF" when checking or replacing a fuse. 1. Remove: Rider seat Refer to "GENERAL CHASSIS" on page 4-1. 2. Check: Fuse a. Connect the pocket te ...