Yamaha YZF-R125 Service Manual: Troubleshooting

  • Any of the following fail to light: turn signal lights, brake light or indicator lights.
  • The horn fails to sound.
  • The fuel gauge fails to operate.
  • The speedometer fails to operate.

NOTE:

  • Before troubleshooting, remove the following part(s):

1. Seats

2. Fuel tank

3. Left upper side cowling

4. Right side panel

5. Left lower side cowling

Troubleshooting


Troubleshooting


Troubleshooting


    Circuit diagram
    4. Main fuse 5. Main switch 9. Battery 14.Neutral switch 25.ECU (engine control unit) 31.Fuel sender 34.Rear brake light switch 35.Front brake light switch 37.Tail/brake light 38.Rear rig ...

    Cooling system
    ...

    Other materials:

    Removing the rear wheel (disc)
    1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. 2. Elevate: Rear wheel NOTE: Place the vehicle on a suitable stand so that the rear wheel is elevated. 3. Remove: Rear brake caliper NOTE: ...

    Replacing an auxiliary light bulb
    This model is equipped with two auxiliary lights. If an auxiliary light bulb burns out, replace it as follows. Remove the socket (together with the bulb) by pulling it out. Auxiliary light bulb Remove the burnt out bulb by pulling it out. Insert a new bulb into t ...

    Intake air pressure sensor
    1. Check: Intake air pressure sensor output voltage Out of specification Replace the throttle body. a. Connect the pocket tester (DC 20 V) to the throttle body sensor assembly coupler as shown. Positive tester probe pink/white "1" Negative tester probe gray/black "2" ...

    2024 Copyright www.yam-r125.net |