Yamaha YZF-R125 Service Manual: Troubleshooting
The starter motor fails to turn.
NOTE:
- Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Left lower side cowling
4. Left upper side cowling
Starting circuit cut-off system operation
If the engine stop switch is set to "
" and the main switch is set to
"ON" (both switches are closed), the
starter motor can only operate if at least one of the following conditions is
met:
...
Charging system
...
Other materials:
Battery
A poorly maintained battery will corrode
and discharge quickly. The electrolyte
level, battery lead connections and
breather hose routing should be
checked before each ride and at the intervals
specified in the periodic maintenance
and lubrication chart.
WARNING
Electrolyte is pois ...
Checking the front wheel
1. Check:
Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNINGDo not attempt to straighten a bent wheel
axle.
2. Check:
Tire
Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING TH ...
Assembling the front brake caliper
WARNING
Before installation, all internal brake components
should be cleaned and lubricated
with clean or new brake fluid.
Never use solvents on internal brake components
as they will cause the brake caliper
dust seals and piston seals to swell and
distort.
...