Yamaha YZF-R125 Service Manual: Swingarm

Installing the rear shock absorber assembly

1. Install: Rear shock absorber assembly Relay arm "1" NOTE: Install the relay arm as shown in the illustration. 2. Tighten: Rear shock absorber assembly upper nut Relay arm nu ...

Removing the swingarm

1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. NOTE: Place the vehicle on a suitable stand so that th ...

Other materials:

Checking the brake fluid level
1. Stand the vehicle on a level surface. NOTE: Place the vehicle on a suitable stand. Make sure the vehicle is upright. 2. Check: Brake fluid level Below the minimum level mark "a" → Add the recommended brake fluid to the proper level. A. Front brake B. Rear brake WA ...

Installing the starter clutch
1. Install: Starter clutch assembly Starter clutch bolts "1" NOTE: While holding the generator rotor "2" with the sheave holder "3", tighten the starter clutch bolts. Do not allow the sheave holder to touch the projection on the generator rotor. Stake the end "a" of each start ...

Installing the steering head
1. Lubricate: Upper bearing Lower bearing Bearing races 2. Install: Lower ring nut Rubber washer Upper ring nut Lock washer Refer to "CHECKING AND ADJUSTING THE STEERING HEAD" on page 3-22. 3. Install: Upper bracket Steering stem nut NOTE: Temporarily tighten t ...