In order for the ignition circuit cut-off system to enable starting, one of the following conditions must be met:
1. Turn the key to "ON" and make sure that the engine stop switch is set to"".
The following warning lights and indicator light should come on for a few seconds, then go off.
NOTICE
If a warning or indicator light does
not go off, see page 3-2 for the corresponding
warning and indicator
light circuit check.
If the engine fails to start, release the start switch, wait a few seconds, and then try again. Each starting attempt should be as short as possible to preserve the battery. Do not crank the engine more than 10 seconds on any one attempt.
Checking the transmission
1. Measure:
Main axle runout
(with a centering device and dial gauge "1")
Out of specification Replace
the main axle.
2. Measure:
Drive axle runout
(with a centering device and dial gauge "1")
Out of specification Replace
the drive axle.
3. Check:
Transmiss ...
Checking the water pump
1. Check:
Water pump housing cover
Water pump housing
Cracks/damage Replace.
Impeller shaft
Cracks/damage/wear Replace.
Bearing
Rough movement Replace.
Radiator outlet hose
Cracks/damage Replace.
...
Introduction
WARNINGDisc brake components rarely require
disassembly.
Therefore, always follow these preventive
measures:
Never disassemble brake components unless
absolutely necessary.
If any connection on the hydraulic brake
system is disconnected, the entire brake
sy ...