The sidestand is located on the left side of the frame. Raise the sidestand or lower it with your foot while holding the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
WARNING
The vehicle must not be ridden with
the sidestand down, or if the sidestand
cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the responsibility
of raising the sidestand before
starting off. Therefore, check
this system regularly as described below and have a Yamaha dealer repair
it if it does not function properly.
Checking the starter motor operation
1. Check:
Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-9.
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
W ...
Chain drive
Removing the drive chain
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated. ...
Checking the front fork legs
The following procedure applies to both of the
front fork legs.
1. Check:
Inner tube
Outer tube
Bends/damage/scratches
Replace.
WARNINGDo not attempt to straighten a bent inner
tube as this may dangerously weaken it.
2. Measure:
Spring free length "a"
Out of sp ...