Yamaha YZF-R125 Owners Manual: Rider seat

To remove the rider seat

  1. Insert the key into the seat lock, and then turn it clockwise.


  1. Seat lock

  2. Open.

  1. Pull the rider seat off.

To install the rider seat

1. Insert the projection on the front of the rider seat into the seat holder as shown.


  1. Projection

  2. Seat holder

  1. Push the rear of the rider seat down to lock it in place.
  2. Turn the key counterclockwise, and then remove it.

TIP
Make sure that the rider seat is properly secured before riding.

    Catalytic converters
    This vehicle is equipped with catalytic converters in the exhaust system. WARNING The exhaust system is hot after operation. To prevent a fire hazard or burns: Do not park the vehicle nea ...

    Sidestand
    The sidestand is located on the left side of the frame. Raise the sidestand or lower it with your foot while holding the vehicle upright. TIP The built-in sidestand switch is part of the ign ...

    Other materials:

    Checking the shift shaft
    1. Check: Shift shaft Bends/damage/wear Replace. Shift shaft spring Damage/wear Replace. Checking the stopper lever 1. Check: Stopper lever Bends/damage Replace. Roller turns roughly Replace the stopper lever. Stopper lever spring Damage/wear Replace. ...

    Removing the handlebars
    1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. 2. Remove: Handlebar grip "1" NOTE: Blow compressed air between the handlebar and the handlebar grip, and gradually push the grip off the handleb ...

    Checking the shift forks
    The following procedure applies to all of the shift forks. 1. Check: Shift fork cam follower "1" Shift fork pawl "2" Bends/damage/scoring/wear Replace the shift fork. 2. Check: Shift fork guide bar Roll the shift fork guide bar on a flat surface. Bends  Replace. ...

    2024 Copyright www.yam-r125.net |