NOTE:
When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper.
1. Remove:
NOTE:
To remove the inner brake pad "1", push down on the brake caliper bracket so that there is space to remove the brake pad.
2. Measure:
Brake pad wear limit "a" Out of specification → Replace the brake pads as a set.
3. Install:
NOTE:
Always install new brake pads and a new brake pad spring as a set.
a. Connect a clear plastic hose tightly to the bleed screw. Put the other end of the hose into an open container.
b. Loosen the bleed screw and push the brake caliper piston into the brake caliper with your finger.
c. Tighten the bleed screw.
d. Install a new brake pad spring "1" and new brake pads.
NOTE:
Install the brake pad spring as shown.
4. Install:
5. Install:
6. Check:
Refer to "CHECKING THE BRAKE FLUID LEVEL" on page 3-18.
7. Check:
Refer to "BLEEDING THE HYDRAULIC BRAKE SYSTEM" on page 3-20.
Faulty lighting or signaling system
Headlight does not come on
- Wrong headlight bulb
- Too many electrical accessories
- Hard charging
- Incorrect connection
- Improperly grounded circuit
- Poor contacts (main or light switch)
- Burnt-out headlight bulb
Headlight bulb burnt out
- Wrong headlight bulb
- Faulty battery
- Fau ...
Installing the throttle body
1. Install:
Throttle body joint clamps
NOTE:
Align the projections "a" on the throttle body joint
with the slot "b" in each throttle body joint clamp.
2. Install:
Throttle body joint
NOTE:
Align the projection "a" on the throttle body joint
with the slot "b" in the intake mani ...
Installing the radiator
1. Fill:
Cooling system
(with the specified amount of the recommended
coolant)
Refer to "CHANGING THE COOLANT" on
page 3-15.
2. Check:
Cooling system
Leaks Repair or replace any
faulty part.
3. Measure:
Radiator cap opening pressure
Below the specified pressure Repla ...