The following procedure applies to the low beam headlight bulb.
1. Remove:
2. Remove:
3. Remove:
WARNING Since the headlight bulb gets extremely hot, keep flammable products and your hands away from the bulb until it has cooled down. |
4. Install:
CAUTION: Avoid touching the glass part of the headlight bulb to keep it free from oil, otherwise the transparency of the glass, the life of the bulb and the luminous flux will be adversely affected. If the headlight bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner. |
5. Install:
6. Install:
The following procedure applies to the high beam headlight bulb.
1. Remove:
2. Disconnect:
3. Remove:
4. Remove:
WARNING Since the headlight bulb gets extremely hot, keep flammable products and your hands away from the bulb until it has cooled down. |
5. Install:
Headlight bulb
Secure the new headlight bulb with the headlight
bulb holder.
CAUTION: Avoid touching the glass part of the headlight bulb to keep it free from oil, otherwise the transparency of the glass, the life of the bulb and the luminous flux will be adversely affected. If the headlight bulb gets soiled, thoroughly clean it with a cloth moistened with alcohol or lacquer thinner. |
6. Install:
7. Connect:
8. Install:
Disassembling the water pump
1. Remove:
Water pump seal "1"
NOTE:
Remove the water pump seal from the inside of
the water pump housing "2".
2. Remove:
Bearing "1"
NOTE:
Remove the bearing from the outside of the water
pump housing "2".
...
Checking the front fork
The condition and operation of the front
fork must be checked as follows at the
intervals specified in the periodic maintenance
and lubrication chart.
To check the condition
Check the inner tubes for scratches,
damage and excessive oil leakage.
To check the operation
Place the vehicle ...
Checking the clutch housing
1. Check:
Clutch housing dogs "1"
Damage/pitting/wear
Deburr the clutch
housing dogs or replace the clutch housing.
NOTE:
Pitting on the clutch housing dogs will cause erratic
clutch operation.
2. Check:
Bearing
Damage/wear Replace the
bearing and
clutch housin ...