Yamaha YZF-R125 Owners Manual: Replacing the fuses

Yamaha YZF-R125 Owners Manual / Periodic maintenance and adjustment / Replacing the fuses

Replacing the fuses

Fuse box
Spare fuse
Headlight fuse
Signaling system fuse
Ignition fuse
Radiator fan fuse
Main fuse

The fuse box is located under the rider seat.

If a fuse is blown, replace it as follows.

Turn the key to "OFF" and turn off the electrical circuit in question.
Remove the blown fuse, and then install a new fuse of the specified amperage. WARNING! Do not use a fuse of a higher amperage rating than recommended to avoid causing extensive damage to the electrical system and possibly a fire.

Specified fuses:

Main fuse:

20.0 A

Ignition fuse:

7.5 A

Signaling system fuse:

7.5 A

Headlight fuse:

15.0 A

Radiator fan fuse:

5.0 A

Turn the key to "ON" and turn on the electrical circuit in question to check if the device operates.
If the fuse immediately blows again, have a Yamaha dealer check the electrical system.

Battery

A poorly maintained battery will corrode and discharge quickly. The electrolyte level, battery lead connections and breather hose routing should be checked before each ride and at the interval ...

Replacing a headlight bulb

This model is equipped with quartz bulb headlights. If a headlight bulb burns out, have a Yamaha dealer replace it and, if necessary, adjust the headlight beam. ...

Other materials:

Front wheel
To remove the front wheel WARNING To avoid injury, securely support the vehicle so there is no danger of it falling over. Loosen the front wheel axle pinch bolt, then the wheel axle and the brake caliper bolts. Front wheel axle pinch bolt Lift the front wheel of ...

Checking the rear brake disc
1. Remove: Rear wheel Refer to "REAR WHEEL" on page 4-12. 2. Check: Brake disc Damage/galling → Replace. 3. Measure: Brake disc deflection Out of specification → Correct the brake disc deflection or replace the brake disc. Refer to "CHECKING THE FRONT BRAKE DIS ...

Checking the rear brake hose
1. Check: Brake hoses "1" Cracks/damage/wear Replace. 2. Check: Brake hose holder "2" Loose connection Tighten the holder bolt. Loose or open holder Fasten properly. 3. Hold the vehicle upright and apply the rear brake several times. 4. Check: Brake ho ...