Yamaha YZF-R125 Owners Manual: Replacing a turn signal light bulb

  1. Remove the turn signal light lens by removing the screw.


  1. Screw

  1. Remove the burnt-out bulb by pushing it in and turning it counterclockwise.
  2. Insert a new bulb into the socket, push it in, and then turn it clockwise until it stops.
  3. Install the lens by installing the screw. NOTICE: Do not overtighten the screw, otherwise the lens may break.

    Tail/brake light
    This model is equipped with an LEDtype tail/brake light. If the tail/brake light does not come on, have a Yamaha dealer check it. ...

    Replacing the license plate light bulb
    Remove the socket (together with the bulb) by pulling it out. License plate light bulb Remove the burnt-out bulb by pulling it out. Insert a new bulb into the socket. ...

    Other materials:

    Replacing the air filter element and cleaning the check hose
    The air filter element should be replaced at the intervals specified in the periodic maintenance and lubrication chart. Have a Yamaha dealer replace the air filter element more frequently if you are riding in unusually wet or dusty areas. In addition, the air filter check hose must be ...

    Removing the front wheel (disc)
    1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. 2. Elevate: Front wheel NOTE: Place the vehicle on a suitable stand so that the front wheel is elevated. 3. Remove: Front brake caliper NO ...

    Checking the drive sprocket
    1. Check: Drive sprocket More than 1/4 tooth "a" wear Replace the drive chain sprockets as a set. Bent teeth Replace the drive chain sprockets as a set. b. Correct 1. Drive chain roller 2. Drive chain sprocket Checking the rear wheel sprocket Refer to "CHECKING AND R ...

    2024 Copyright www.yam-r125.net |