Yamaha YZF-R125 Service Manual: Replacement parts

Use only genuine Yamaha parts for all replacements.

Use oil and grease recommended by Yamaha for all lubrication jobs. Other brands may be similar in function and appearance, but inferior in quality.

Replacement parts


    Preparation for removal and disassembly
    1. Before removal and disassembly, remove all dirt, mud, dust and foreign material. 2. Use only the proper tools and cleaning equipment. Refer to "SPECIAL TOOLS" on page 1-8. 3. When disas ...

    Gaskets, oil seals and o-rings
    1. When overhauling the engine, replace all gaskets, seals and O-rings. All gasket surfaces, oil seal lips and O-rings must be cleaned. 2. During reassembly, properly oil all mating parts and be ...

    Other materials:

    Checking the valve springs
    The following procedure applies to all of the valve springs. 1. Measure: Valve spring free length "a" Out of specification Replace the valve spring. 2. Measure: Compressed valve spring force "a" Out of specification Replace the valve spring. b. Installed length 3. ...

    Checking the diode
    1. Check: Diode Out of specification Replace. NOTE: The pocket tester or the analog pocket tester readings are shown in the following table. a. Disconnect the diode from the wire harness. b. Connect the pocket tester ( × 1) to the diode terminals as shown. c. Check the diod ...

    Checking the rear wheel
    1. Check: Rear wheel axle Rear wheel Wheel bearings Oil seals Refer to "CHECKING THE FRONT WHEEL" on page 4-8. 2. Check: Tire Rear wheel Damage/wear → Replace. Refer to "CHECKING THE TIRES" on page 3-23 and "CHECKING THE WHEELS" on page 3-25. 3. Measure: Radi ...

    2024 Copyright www.yam-r125.net |