1. Stand the vehicle on a level surface.
WARNING Securely support the vehicle so that there is no danger of it falling over. |
2. Elevate:
NOTE:
Place the vehicle on a suitable stand so that the rear wheel is elevated.
3. Remove:
NOTE:
Do not depress the brake pedal when removing the rear wheel.
4. Loosen:
5. Remove:
NOTE:
Push the rear wheel forward and remove the drive chain from the rear wheel sprocket.
Disassembling the rear wheel
1. Remove:
Checking the fuel line
1. Remove:
Left side panel
Refer to "GENERAL CHASSIS" on page 4-1.
2. Lift the fuel tank. (Do not disconnect the fuel
hose, drain hose
3. Check:
Fuel hose "1"
Cracks/damage → Replace.
Loose connection Connect properly.
4. Install:
Fuel tank
Refer to "FUEL TANK" on pa ...
Removing the starter clutch
1. Remove:
Starter clutch bolts "1"
NOTE:
While holding the generator rotor "2" with the
sheave holder "3", remove the starter clutch
bolts.
Do not allow the sheave holder to touch the
projection on the generator rotor.
...
Installing the rear brake master cylinder
1. Install:
Copper washers "1"
Brake hose "2"
Rear brake light switch "3"
WARNINGProper brake hose routing is essential to
insure
safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-33.
CAUTION:When installing the brake hose onto the
brake master ...