Yamaha YZF-R125 Service Manual: Removing the rear brake caliper

Yamaha YZF-R125 Service Manual / Chassis / Rear brake / Removing the rear brake caliper

NOTE:

Before disassembling the brake caliper, drain the brake fluid from the entire brake system.

1. Remove:

  • Union bolt "1"
  • Copper washers "2"
  • Brake hose "3"

Removing the rear brake caliper


NOTE:

Put the end of the brake hose into a container and pump out the brake fluid carefully.

    Replacing the rear brake pads
    NOTE: When replacing the brake pads, it is not necessary to disconnect the brake hose or disassemble the brake caliper. 1. Remove: Brake pads Brake pad spring NOTE: To remove the inner b ...

    Disassembling the rear brake caliper
    1. Remove: Brake caliper piston "1" Brake caliper piston dust seal "2" Brake caliper piston seal "3" a. Blow compressed air into the brake hose joint opening "a" to force out the pisto ...

    Other materials:

    Checking the swingarm
    1. Check: Swingarm Bends/cracks/damage   Replace. 2. Check: Pivot shaft Roll the pivot shaft on a flat surface. Bends Replace. WARNINGDo not attempt to straighten a bent pivot shaft. 3. Wash: Pivot shaft Washer Swingarm adjusting collar Du ...

    Cleaning and lubricating the drive chain
    The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it will quickly wear out, especially when riding in dusty or wet areas. Service the drive chain as follows. NOTICE The drive chain must be lubricated ...

    Installing the swingarm
    1. Lubricate: Bearings Spacers Dust covers Pivot shaft 2. Install: Bearings "1" 2. Swingarm A. Left side B. Right side 3. Install: Swingarm adjusting collar "1" Swingarm "2" Pivot shaft Pivot shaft nut "3" a. Install, and then fully turn in the swingarm adju ...

    2024 Copyright www.yam-r125.net |