1. Loosen:
NOTE:
Place the aluminum plate "a" between the balancer drive gear "2" and the balancer driven gear "3", and then loosen the primary drive gear nut.
2. Straighten the lock washer tab.
3. Loosen:
NOTE:
Place the aluminum plate "a" between the balancer drive gear "2" the and the balancer driven gear "3", and then loosen the balancer driven gear nut.
Checking the front fork
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Check:
Inner tube
Damage/scratches Replace.
Oil seal
Oil leakage Replace.
3. Hold the vehicle upright and apply the front
brake.
4. Che ...
Installing the front wheel (disc)
1. Install:
Front brake disc
NOTE:
Be sure to install the front brake disc with the
arrow mark "a" on the disc facing out.
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
Front brake disc
Refer to "CHECKING THE FRONT BRAKE
DISC" on page 4 ...
Electrical components
1. Main switch
2. Clutch switch
3. Front brake light switch
4. Ignition coil
5. Throttle body sensor assembly (intake air
pressure sensor, intake air temperature
sensor, throttle position sensor)
6. FID (fast idle solenoid)
7. Rectifier/regulator
8. Lean angle sensor
9. Starting circui ...