1. Remove:
NOTE:
2. Remove:
CAUTION: To protect the end of the crankshaft, place an appropriate sized socket between the flywheel puller set center bolt and the crankshaft. |
NOTE:
Make sure the flywheel puller is centered over the generator rotor.
Checking the timing chain tensioner
1. Check:
Timing chain tensioner
Cracks/damage/rough movement Replace.
a. Lightly press the timing chain tensioner rod
into the timing chain tensioner housing by
hand.
NOTE:
While pressing the timing chain tensioner rod,
wind it clockwise with a thin screwdriver "1" until
it stops.
b. ...
Engine oil and oil filter element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter element
replaced at the intervals specified
in the periodic maintenance and lubrication
chart.
To check the engine oil level
Place the vehicle on a level surface
and hol ...
Removing the throttle body
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Disconnect:
Fuel hose
WARNINGCover the fuel hose connections with a
cloth
when disconnecting them. Residual pressure
in the fuel lines could cause fuel to
spurt out when removing the h ...