1. Extract the fuel in the fuel tank through the fuel tank filler hole with a pump.
2. Remove:
3. Disconnect:
CAUTION:
|
NOTE:
Before removing the hose, place a few rags in the area under where it will be removed.
4. Remove:
Checking the fuel pump body
1. Check:
Fuel pump body Obstruction Clean.
Cracks/damage Replace the fuel tank.
Setting the diagnostic mode
1. Set the main switch to "OFF" and the engine stop switch to "
".
2. Disconnect the self-diagnosis signal connector "1", and then connect the FI
diagnostic tool "2" as
shown.
3. Disconnect the fuel pump coupler.
4. While pressing the "MODE" button, set the main switch to "ON".
NOTE:
...
General chassis
Installing the air filter case
1. Install:
Air filter case joint clamp
NOTE:
Align the projection "a" on the air filter case with
the slot "b" in the air filter case joint clamp.
...
Checking the rear brake hose
1. Check:
Brake hoses "1"
Cracks/damage/wear
Replace.
2. Check:
Brake hose holder "2"
Loose connection Tighten the
holder bolt.
Loose or open holder Fasten
properly.
3. Hold the vehicle upright and apply the rear
brake several times.
4. Check:
Brake ho ...