Yamaha YZF-R125 Service Manual: Removing the front wheel (disc)

Yamaha YZF-R125 Service Manual / Chassis / Front wheel / Removing the front wheel (disc)

1. Stand the vehicle on a level surface.

WARNING

Securely support the vehicle so that there is no danger of it falling over.

2. Elevate:

  • Front wheel

NOTE:

Place the vehicle on a suitable stand so that the front wheel is elevated.

3. Remove:

  • Front brake caliper

NOTE:

Do not squeeze the brake lever when removing the front brake caliper.

    Front wheel
    ...

    Disassembling the front wheel
    1. Remove: Oil seal Wheel bearings a. Clean the surface of the front wheel hub. b. Remove the oil seal "1" with a flat-head screwdriver. NOTE: To prevent damaging the wheel, place a rag ...

    Other materials:

    Handlebar switches
    Left Left 1. Pass switch "PASS" 2. Dimmer switch "/" 3. Turn signal switch "/" 4. Horn switch"" Right Right Engine stop switch "/" Start switch"" Pass switch "PASS" Press this switch to flash the headlight. Dimmer switch "/" Set this switch to"" for the high beam an ...

    Installing the rear brake caliper
    1. Install: Brake caliper "1" Copper washers Brake hose "2" Union bolt "3" WARNINGProper brake hose routing is essential to insure safe vehicle operation. Refer to "CABLE ROUTING" on page 2-33. CAUTION:When installing the brake hose onto the brake calip ...

    Adjusting the front wheel static balance
    NOTE: After replacing the tire, wheel or both, the front wheel static balance should be adjusted. Adjust the front wheel static balance with the brake discs installed. 1. Remove: Balancing weight(s) 2. Find: Front wheel's heavy spot NOTE: Place the front wheel on a suitab ...

    2024 Copyright www.yam-r125.net |