NOTE:
Before disassembling the brake caliper, drain the brake fluid from the entire brake system.
1. Remove:
NOTE:
Put the end of the brake hose into a container and pump out the brake fluid carefully.
Checking the connections
Check the leads, couplers, and connectors for
stains, rust, moisture, etc.
1. Disconnect:
Lead
Coupler
Connector
2. Check:
Lead
Coupler
Connector
Moisture → Dry with an air blower.
Rust/stains → Connect and disconnect several
times.
3. Check:
All co ...
Installing the valves
The following procedure applies to all of the
valves and related components.
1. Deburr:
Valve stem end
(with an oil stone)
2. Lubricate:
Valve stem "1"
Valve stem seal "2"
(with the recommended lubricant)
3. Install:
Lower spring seat "1"
Valve stem seal "2"
V ...
Checking the piston pin
1. Check:
Piston pin
Blue discoloration/grooves
Replace the
piston pin and then check the lubrication system.
2. Measure:
Piston pin outside diameter "a"
Out of specification Replace
the piston pin.
3. Measure:
Piston pin bore diameter "b"
Out of specifica ...