1. Align:
a. Turn the crankshaft counterclockwise.
b. When the piston is at TDC on the compression stroke, align the "I" mark "c" on the camshaft sprocket with the mark "d" on the cylinder head.
2. Loosen:
NOTE:
While holding the generator rotor nut with a wrench "2", loosen the camshaft sprocket bolt.
3. Remove:
NOTE:
To prevent the timing chain from falling into the crankcase, fasten it with a wire "1".
4. Remove:
NOTE:
Checking the front brake lever free play
Checking the front brake lever free play
Brake lever free play
The brake lever free play should measure
2.0-5.0 mm (0.08-0.20 in) as
shown. Periodically check the brake lever
free play and, if necessary, have a
Yamaha dealer check the brake system.
WARNING
An incorrect brake le ...
Checking the cooling system
1. Remove:
Side covers
Upper side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Radiator "1"
Radiator inlet hose "2"
Radiator outlet hose "3"
Coolant reservoir hose "4"
Water pump breather hose "5"
Cracks/damage → Replace.
Refer to "RADIATOR" on page 6-1 ...
Adjusting the throttle cable free play
Throttle cable free play
The throttle cable free play should measure
3.0-5.0 mm (0.12-0.20 in) at the
throttle grip. Periodically check the
throttle cable free play and, if necessary,
adjust it as follows.
TIP
The engine idling speed must be correctly
adjusted before checkin ...