Yamaha YZF-R125 Service Manual: Removing the crankshaft

Yamaha YZF-R125 Service Manual / Engine / Crankshaft / Removing the crankshaft

1. Remove:

Crankshaft "1"

NOTE:

Remove the crankshaft with the crankcase separating tool "2".
Make sure the crankcase separating tool is centered over the crankshaft.

CAUTION:

To protect the end of the crankshaft, place an appropriate sized socket between the crankcase separating tool bolt and the crankshaft.
Do not tap on the crankshaft.

Removing the crankshaft

Checking the crankshaft

1. Measure: Crankshaft runout Out of specification Replace the crankshaft, bearing or both. NOTE: Turn the crankshaft slowly. 2. Measure: Big end side clearance Out of speci ...

Other materials:

Checking the horn
1. Check: Horn resistance Out of specification Replace. a. Disconnect the horn connectors from the horn terminals. b. Connect the pocket tester ( × 1) to the horn terminals. Positive tester probe horn terminal "1" Negative tester probe horn terminal "2" c. Measure t ...

Special tools
The following special tools are necessary for complete and accurate tune-up and assembly. Use only the appropriate special tools as this will help prevent damage caused by the use of inappropriate tools or improvised techniques. Special tools, part numbers or both may differ depending on the ...

Checking and lubricating the cables
The following procedure applies to all of the inner and outer cables. WARNINGDamaged outer cable may cause the cable to corrode and interfere with its movement. Replace damaged outer cable and inner cables as soon as possible. 1. Check: Outer cable Damage Replace. 2 ...